Spec-D Tuning 2012 Honda Civic Projector Headlights Installation Instructions
Projector and aftermarket headlights in general are a great way to spice up the look of your car. In addition, many high-quality projector lights not only increase the aesthetic appeal of your ride but also augment its performance. Imagine the difference that additional candlepower can make on a winding country road or in the middle of an intense storm. Still for many people, installing aftermarket headlights can seem like a task best left to the experts. But, as you will see that is not the case at all.
Preparations
You will need the following tools before you attempt to install the headlight and most of these are included in any standard tool box. Please contact us if you have any problems finding any of the tools listed above.- 1.4" drive ratchet
- a 6" extension
- 10m socket
- 5mm Allen socket
- a Handy remover
1. Open the hood. Yes, it may at first seem like a no-brainer but it is an important first step.
2. Remove the 12 plastic clips shown above. Be gentle as you do not want to snap these clips.
3. Remove the Phillips head screw from the fender well. A Phillips head screwdriver has the cross end as opposed to the flat head.
4. Remove the two 5mm Allen bolts shown above.
5. Remove the two plastic clips located at the top of the radiator supports. Again, be gentle with the fragile clips.
6. Remove the front bumper by tugging firmly at the sides.
7. Remove the impact absorbing foam. Here, too, patience is the key.
8. Remove the 10mm bolt that secures the headlight to the frame. These is the first of 3.
9. Remove the 10mm bolt located to the side of the headlight. Number two!
10. Remove the third 10mm connecting the bracket to the frame
11. Remove headlight and disconnect headlight harness. There are two plug to disconnect here.
12. Remove the 10mm bolt attaching the headlight to the factory headlight bracket.
13. Remove the headlight bracket.
14. Install the headlight bracket on the new headlight and secure it with a 10mm bolt.
15. Connect the headlight harness to new headlight and place in factory position.
16. Replace all hardware by following steps 1 through 13 in reverse order.
17. Check all connections and light functions prior to driving
No comments:
Post a Comment